> When issuing goods out due to the manufacturing process is there a way
> to know in advance which inventory item ID the manufacturing process
> will issue the components out of?
This should - at least, and with current code - be visible in the
production run in section regarding material issued (when administratively
the goods are issued). The production worker then knows where to pick the
goods in the physical warehouse.
If you would a more staggered solution, then code adjustments are required.
E.g. where your MRP process creates the picking order in the Catalog
> This information would be helpful for
> a picker to go the the right location sequence ID/bin to grab the right
> product if located in multiple locations. When the manufacturing
> process is complete is there a way to indicate where you want the finish
> good to reside as far as the location sequence ID.
Again this should be visible in the production run. And the production
worker should be able to place the goods in the correct location in the
> On the opposite side as far as reverse assembly is concerned...is there
> a way to indicate which location you want to grab a product to reverse
> assemble. Is there a way to indicate the products generated from that
> process where they reside?
Reverse assembly? Isn't that disassembly?
I guess the same reasoning as for assembly can be applied thereon. See your
answers and my response above.